Television and Home Theater

Mitsubishi WS-65869 replaced 7 caps, still have a prob. HELP PLZ

I have a Mitsubishi WS-65869 which has the blinking green timer light. Attempting to turn the power on did nothing, I only saw the blinking green timer light. I followed the repair guide to replace the 7 capacitors (bought from Radio Shack). After putting everything back together and connecting the TV to the power outlet, the light blinked for about a minute just as the guide said it would. I then turned on the TV and could hear that the TV did turn on as it wasnt doing before, but there was nothing on the screen.

Sony KV-27TS29

I am reparing the above Sony TV there is a 4 inch black bar across the bottom of the screen so the picture is pushed up, I do not see any vertical adjustment controls on the circuit board. Any suggestions as to where to concentrate is appreciated.

wd-62725 Black Screen - Error Code 12

Hello,

Mitsubishi projection 65513 blinks after pressing on with remote

Evil, Thanks for your responses. When I press the ON  button with the remote the green light rapidly blinks for a few minutes(more than 2) and goes off , then the TV actually turns on. Sometimes it only blinks for a few minutes and does nothing.  I am aware blinking for a minute after plugging it in is normal. This isn't the case as the tv has been plugged in for days when trying to power it on. It used to be that I had to push the reset button with a paperclip for ten seconds and release and it would blink for a minute and then I could turn it on.

How do you read the numbers on top of capacitors?

Hi all,

I have a mitsubishi wd-52725 with a bad FMT board.

Panasonic Viera not picking up channels at turn on

Hey all, I have done a search and cant find anything to help so I am hoping one of you good people may be able to oblige

 

When I turn on my Panasonic Viera tv (TX-32LMD70A), usually I get the RED light flashing in the bottom left hand corner and then a picture flashes up for a mili-second before the screen goes blank again (with the RED light back again).

It usually takes a few presses ON and OFF before the picture stays.

Pages

 

Connect With Techlore