It blinks so fast you cannot count and there are no pauses, like when it's putting out a code. I think there is a problem in the HV circuit. When the K9A50 relay energizes you can hear a high freq noise then the realy clicks off and the light on the front start blinking. Then after about 15sec the whole thing starts over again, without pressing the "On" button. It's like it's trying to fire up the CRT's, but dosen't. I may be way off base, I don't really know. I'm willing to try anything except replacing every board. It's not worth that.
The code it flashed was 12. I let it do this for longer than ususal and noticed the red CRT was lighting up, but nothing from the other 2. Also the time it stays lit is about 3 secs then it cuts off and the timer lamp blinks for about 5 secs and it starts over again. Why would only 1 CRT fire up?
It blinks so fast you cannot count and there are no pauses, like when it's putting out a code. I think there is a problem in the HV circuit. When the K9A50 relay energizes you can hear a high freq noise then the realy clicks off and the light on the front start blinking. Then after about 15sec the whole thing starts over again, without pressing the "On" button. It's like it's trying to fire up the CRT's, but dosen't. I may be way off base, I don't really know. I'm willing to try anything except replacing every board. It's not worth that.
After it does all that try holding the menu and device button for 6 seconds on the tv.
The code it flashed was 12. I let it do this for longer than ususal and noticed the red CRT was lighting up, but nothing from the other 2. Also the time it stays lit is about 3 secs then it cuts off and the timer lamp blinks for about 5 secs and it starts over again. Why would only 1 CRT fire up?
Pages