Television and Home Theater

RCA TV F35750ST TV

Submitted by TopDrop106 on Sat, 04/07/2007 - 16:29

Forums: 

I own an RCA TV  Model F35750ST chassis CTC169BG5. The right speaker works but has a steady hum in it. Can assist be given to repair? I am the original owner purchased this "heavyweight" in 1994. Thanks.

problems

Submitted by bob628 on Sat, 04/07/2007 - 14:02

Forums: 

I just got a new vizio p50hdtv10a. Its a plasma. When i press the power button the tv's light blinks from green to red and there is no picture. some time its turns on right, but most of the time it doesn't.

Skipping channels on older TV set

Submitted by trumpy on Fri, 04/06/2007 - 21:58

Forums: 

Hi there,

I have an older Mitsubishi portable TV model No CT1447AM(B).  I would like to know how to skip channels on it.  There are no manuals available, nothing on the remote to help and no on screen menu facility.  Inside the panel on the front there are buttons for tuning, SW Band selector, AFT, volume etc but I'm at a loss when trying to get rid of unwanted channels. Any help appreciated thanks!

Sony KV-27S45 Volume low,even at max;wavy lines on the screen

Submitted by Dragans on Fri, 04/06/2007 - 02:18

Forums: 

Hello, this is my first post here.

Sony KV-27S45 (BA-4 chassis) has low volume,even at maximum setting. When the fixed or variable audio out is connected to an external audio amp there is normal sound .IC401(TDA7057AQ) has been replaced with no changes in the symptom. Also there are wavy lines on the screen.

Any help, please?

Thanks!

Dragan

hook up big screen

Submitted by U.L. on Thu, 04/05/2007 - 16:25

Forums: 

I bought a used vs-45607 the other day and it did not have a manual with it or a remote. I need to know how to hook it up to the satillite receiver. Any help would be much appriciated in this matter.

Sony trinitron kv-28ls60u 3 blink fault

Submitted by littlejohn on Thu, 04/05/2007 - 16:25

Forums: 

Firstly id like the say hi,

Heres my problem i have a sony trinitron tv model kv-28ls60u and it has the three blink problem ive searched the forum and found this

 

[quote]Three blinks - B+ over voltage protection (OVP), unit goes to the standby mode then displays the 3 blink fault. This is also a problem in the power supply circuit, check T603 and R672.[/quote]

Pages

 

Recent comments

more
 

Connect With Techlore

Privacy Policy | Terms of Use | About Us | Contact Us | Site Map

Copyright © 2020

 

Our NetWork

MyOpenRouter

Media Smart Home

Magenium Solutions

EHome Design

See all...