Television and Home Theater

Sylvania 6420FE loss of audio

Looking for an assist. My 6420FE audio will quit approx 2 minutes after the set is turned on. However if you are using A/V Input 1 (DVD) or A/V Input 2 (VHS) the audio works correctly.  It only affects the Cable/Antenna jack on the back of the set.    Any ideas as to what component is the cause?

 Thanks

gus

Toshiba Theaterwide losing picture with cable

two or three years ago, we had digital cable installed for our
Toshiba 42H82 HDTV. immediately thereafter, we began experiencing
problems with losing picture.  consistently what will happen after
watching the tv for a couple of minutes or so, the picture will begin
to cut out.  sound is never affected, but the picture will
continue to go in and out until we turn it off.

Help! very confused......

I have a Symphonic ST423E TV. It has worked great until just recently when the sound stopped working. I can't control the volume from the TV or the remote. I still get a picutre but there is no sound what-so-ever. Please help!!

Help! very confused......

I have a Symphonic ST423E TV. It has worked great until just recently when the sound stopped working. I can't control the volume from the TV or the remote. I still get a picutre but there is no sound what-so-ever. Please help!!

RCA F27665 TV

The sound on my TV was working fine and while I was changing channels the sound went to all static. The picture is fine. Not sure what to check for this. Thanks.

Toshiba CZ32T31 TV

When I turn on my Toshiba TV, the screen is blank, there is no sound and the red power light is on. I found that fuse F301 (500ma) was blown and resistor R327 (5.6 ohm) was open. I replaced both of them but the resistor keeps burning up and the fuse keeps blowing. I don't have a schematic and I am not sure what components to check. Any ideas? Thanks.

Pages

 

Connect With Techlore