Television and Home Theater

I need the original settings for a Sony KP61S70

I was fiddling with the service menu settings on my TV and lost the paper that I had the original settings written down. No!!!!

To enter the Service Menu turn off the TV.

Using your remote enter [Disp],[5],[Vol+],[Power].

You'll see some numbers on the top of your screen.

To navigate : [1]for UP [4]for Down

(!AVOID PRESSING [3] AND [6] ALSO THE CENTER ARROW KEYS!)

If someone could please send or post their screen settings.

Sony KP-43HT20 Convergence Issue

Just as I was preparing to trash my 5 1/2 year old Sony for the red lines that diverge at the top left and bottom right corners, my lovely wife came across this fantastic forum. I think I have a convergence problem and I need to buy two STK392-560 Convergence ICs and Heatstick Compound. I guess I also need a desoldering iron. Where do you buy this stuff, anyway?

Need help with my Phillips 26PF5321D/37

The Power just recently went out I uplugged it left it unplugged all night and still would not power up I assumed it was the fuse as I tested it with a volt meter and got a zero reading I got the replacement fuse and still no power any other ideas would be greatly appriciated.

Thanks,

Steve

blinking light

Larry, i fixed the problem with the blinking light when turning on the tv, but now when i turn off the tv it shuts down. then the blinking light starts again but only slower and for about a minute it blinks then shuts off totally. i have the power saving mode on so when the tv is started it is normal to blink for a minute, but never saw the blinking light when you turn off the tv. any help would be appreciated. ajy

Sony screen blank/no sound and light blinking 4 times

My Sony projection big screen KP-61HS10 has quit working.  When power is turned on, TV clicks like it is powering up like normal, then clicks again and powers down with the red light blinking 4 times.  TV has been working great for last 7 years, except for the last 6 months the TV has had a poor picture (green blue and red not aligned) for the first 10 minutes.  After fully warmed up, the picture is perfectly aligned and clear.

Caps For repairng Mitsubishi DM/Power Supply

Larry,

Would you please send the link for the Caps needed to repair my Mitsubishi "blinking green Light" problem. I had a system failure and lost everything.  Fortunately for me, I had printed out the repair docs before the crash.  I am going to give the repair a try and see where that goes..

krgoodnight at comcast dot net is the email address.  Thanks much

Kyle

Pages

 

Connect With Techlore