Television and Home Theater

hi

THE PROBLEM I HAVE IS THAT THE DAWOO TV DTY29G4 IS STUCK IN STANDBY HOW COULD I GET IT OFF STANDBY TO WATCH THE TV

Dear Person:

I have an RCA P46731AT with a PTK169pga board..The pix is curved on both sides (inward)...There is a small board mounted by the flyback that has 3 adjustments on it...

One is "Horiz Width" & it works perfectly...
The 2nd is "Horiz Phase / Trap" that gives little effect...
The 3rd is the "Pin Amp Adjust" (R-4805) that has NO effect...

There are only 2 lytic caps on that board & I've checked them ( ESR & value)...Both checked OK...

I do NOT have the exact schematic & badly need one...

Larry,

I recently replaced the STK392-570 ic's and pico fuses FA04 and FA05. I plugged everything back in and now the fron power on switch stays green which before it would turn off after about 5seconds. I dont get any video or audio.  Any suggestions Can you also answer the following questions:

1. How do I remove the connectors that interconnect each of the three boards on this model. It felt like I was going to break them, so I wound up doing the chip and fuse replacements with all three pcb's connected. That was a bear.  ??