Television and Home Theater

Sony kp48-s70 convergence problem

 I've read quite a few articles on this site regarding convergence problems and how to repair the problem, however, I can't seem to find info  for my question.  Is it possible  for the convergence ics  to be bad without blowing any of the pico fuses. Would anyone be able to provide voltage readings on these chips?  Any other help on this subject is appreciated.

Panasonic PT56WXF95 Wont turn on

HELP!

  When pluged in, I can turn the unit on with the remote, I hear a relay click, then I hear a clicking/whistle sound that repeats itself at about .5Hz comming from T812 on the PA1646 board.

I have no HV, and no other indications that the power is applied.

This all started one sunday morning, my family was watching the set, when it powered down and would not come up. I have removed the chassis and have inspected it for obvious solder/burnt components/loose connections, etc with no findings.

 

Please help...

Mitsubishi Green Blinking light...WS-65813 and other models

Misubishi WD-73732 Green flashing light Help

My Misubishi hd WD-73732 won't power on or off, the only thing it work is flashing green light .I did try to hold down the power button to reset (no luck), press timer reset (no luck), un plug power cable,then plug it back in (no luck).Can you help.Thanks
[email protected]

Maxent mx-50x3

I have a 50 inch plasma that has vertical lines running across the entire screen in different colors. this occurs when the tv first starts up and then it goes to blue screen after a few mins. This happens when using all inputs. I have been told that it is probably a problem with the image pcb (QPWB11522-1G-2). Looking for some advice and/or insight into the problem.

panasonic turns off after 5 seconds

I have a panasonice PT-51hx41e projection screen tv that will power up for a few seconds before shutting off.  The screen does not come on when powered up for the short time.  Does anyone have an idea where I should start looking for the problem.  If the bulb is blown, will the unit shut down after a few seconds?

 

Thanks

Pages

 

Connect With Techlore