Hello, first time poster here. I am dealing with a convergence problem. I have replaced the two convergence chips but while doing so the pad on pin 7 was damaged to the point the pin no longer takes solder. I am having a problem with 5 amp pico fuse PS5001 blowing. The IC with the bad solder pad is IC8001, I believe there may be a short between the two. I do not have a schematic to trouble shoot the convergence board model number A1302708A. I am wondering if I could jumper pin 7 on the IC to wherever it is supposed to go. Can anybody help me out with this?
Thanks,
Bob
