Convergence when set is cold.

1 post / 0 new
BZBIGSCREEN
Convergence when set is cold.

Thank you guys for all of
your help up front. I have a Sony KP-61HS10. I have been all over this
thing trying to figure out what is going on, but am lost. I have
replaced the convergence chips (as I see so many others have done) due
to the green being way out of wack. Along with the pair of chip I have
replaced 3 of the fuses.... Now to the weird part. Since then the set
seams to work good...accept when it is cold. The convergence is off
till it gets warmed up. I have checked and reheated all the connections
on the chips and fuses to verify no cold solder joints... Still off.
Like I said it looks great once warmed up, but it's just getting to
that point is the problem. The chips I used were Genuine Sony chips, so
I don't think they could be the issue. I was just hoping that someone
might have an idea what could be doing this. I have posted a few
messages in the forum, but no real hits. Any help would be appricated.
Thank you again.

 

Connect With Techlore