I recently replaced my convergence IC's and with the great help of this community I accomplished it without a problem (or so I think). After I replaced and plugged everything back in the TV came on fine, and after some configuring and reseting the TV displayed great.
However I was getting a light error (5 blinks AKB circuit), then after a few times of turning on and off this has stopped. I pulled up the fault codes on the diagnostic screen and it is displaying AKB 1 and has not incremented since. Should this be any cause for concern?
I should also add that the TV has the look of a square "burn-in" after some research it was said the the CRT's could be faulty. Attached pic. With brightness all the way up.
bump.
What color would make grey?