I am experiencing the blinking green light (of death) when the unit is plugged in. Never get a picture or sound. Tried system reset but no help. After green light stops blinking, any button pressed on front panel or remote causes the green light to blink again. This appears to have a V28 chassis. I removed the chassis from the tv and checked all of the fuses (all tested ok) per the guide on the metal support. I found the fuses on the power supply and the DM4 board. Also looked at the capacitors and none looked or felt like they are bulging. Any suggestions on how to repair other than Mitsubishi service would be greatly appreciated. Thanks in advance.
You should replace the caps on the dm broad even if they not look bad just repalce all 6 caps 1000 uf @ 16volts if you can replace with 680 uf @ 16 volts.
Thanks for the response. I pulled the DM card (DM4) and found multiple caps. There are 6 - 680uf @ 10V Nichicon; 3 - 680uf @ 25V Rubycon; 1 - 1000uf @ 6.3V Jamicon and 2 - 330uf @10V Jamicon (all 105 degree C). Which caps do you recommend?
hello,
I have wd-62627 and have promlem with it as a lot people have too. I am experiencing the blinking green light (of death) when the unit is plugged in. Never get a picture or sound. Tried system reset but no help. After green light stops blinking, any button pressed on front panel or remote causes the green light to blink again. Any suggestions on how to repair other than Mitsubishi service would be greatly appreciated. Thanks in advance.