Specific Capacitor replacement question - Mitsubishi (what else?)

First, THANK YOU SO MUCH to everyone out there who has contributed to this site, especially Larry.

So I'm in the middle of the repair of my WD-52825 for the BGLOD.  I replaced the 4 caps on the DM board with the 35V 1000 uF  105degree caps that mostly everyone recommended - 2 were popped.  I also replaced two bad caps of the same spec on the FMT PWB.  There is also a set of the same spec on the upper right corner of the Power PWB that I will replace because one is popped. 

I have two questions:  First, I have two popped caps on the Term 2 PWB that are 10V 1000 uF 105 degree.  What spec would you recommend that I replace them with? 

My other question is that the caps I removed are labelled 105 degrees, not 85 like everyone else had.  Any idea what happened?  Bad brand?

OK, I have a third question.  Since my electrical problems seem to be fairly widespread, how do I check the fuses?

 Thanks for all help!

 -Dave

 drdavekruse (at) gmail.com