Sorry I had to re register- I have about 20+ years soldering, and pretty familiar with PCBs and have an electronics tech / engineering degree and the sets number is A56M91W zenith-The red is leaving a warped ghost image.
You really should get the board number and exchange the entire board, to the registation board, amd replace it. These boards on the Zenith TV sets are avail. as complete unbits. Good luck. Please let us know how you make out with this repair.
I'm having the same problem with a Zenith rear projection tv. The green is off a bit. It bows a bit at the bottom and top edges. Either way, I need to replace the chip, if not the whole board. Where would I get this board once I get the part number? Any help would be greatly appreciated.
How much soldering experience and printed circuit board experience do you have? What is the complete model number of this TV set?
Sorry I had to re register- I have about 20+ years soldering, and pretty familiar with PCBs and have an electronics tech / engineering degree and the sets number is A56M91W zenith-The red is leaving a warped ghost image.
You really should get the board number and exchange the entire board, to the registation board, amd replace it. These boards on the Zenith TV sets are avail. as complete unbits. Good luck. Please let us know how you make out with this repair.
Can you recommend a good place to find the board fair prices Thanks
Whats the number on the convergence board?
Which board is it what components does it have what are its characteristics Thanks Tom
The board should have two large IC's on it that start with STK on the front of them.
I'm having the same problem with a Zenith rear projection tv. The green is off a bit. It bows a bit at the bottom and top edges. Either way, I need to replace the chip, if not the whole board. Where would I get this board once I get the part number? Any help would be greatly appreciated.