Television and Home Theater

LG 50' Plasma

I got a LG 50 inch plasma tv it work fine at first but on HD channels theres a purple hue in bottom right corner with a line running up the screen a couple inchs from edge this can only be seen in HD and the more white the picture is (like on a NHL hockey game  that is in HD) the more you can see the purple hue and white line and help would be appreciated.

ctc 169 red retrace

Hello,

Have worked on many of these early projection sets, however this one is acting up.

original problem was 15v standby diode,and replaced power supply cap with 4.7uf @ 100v in place of the 2.2@ 100v(cant remeber if this matters a whole lot.

Set fired up,and ran no problem. Checking tubes,noticed the red was dark,increased screen and got immediate retrace. Hmmm, changed out Q9206 video buffer.no effect!! swapped crt boards, problem followed, ruled out tube,. had a spare convergence board,swapped no change.

clue? stuck in parental lock.

How to set in service model of Sony KP-XA43M90

Hi, I am new here, I have a old CRT Projection TV , model:Sony KP-XA43M90

here are the problem:

1:pictrue thrill, not serious, but still can see.

2:picture with a black halo, like a scope sight, the centre of screen too bright and all round especially four conner are a little bit dark,

3:I  can enter the service mode, but i don`t know how to adjust. when i first enter, it display "00 VHS 14 SERVICE 50" "236 V4.0C FF 02 00 36" ...... something I can`t understand.

sony kp-57ws500

after replacing stk 392-560 ics set looks exactly the same. i then looked on g bd. and found 5.0 amp pico fuse bad as well as 35v 1000uf. cap bulging. ireplaced these fired set up it startsup then shuts down. will not turn back on can anyone help.

Philips 27PT6441/27 keeps blowing fuses

I've been trying to fix this tv for some time now. I bought the well known PTC replacement and other kits, after replacing all this it keeps blowing fuses. I even checked the net and saw all the postings for this model and the fuse problem. I did what the postings recommended and replaced the original fuse with a slow burn 4A 250v and then a slow burn 5A 250v same problem it blows instantly. I removed the PTC and tried again, same thing. I'm running out of ideas and have never had this much problem with a tv before. Does anyone know what could be wrong with this thing?

Mitsubishi WL-82913 Owners

Does anyone here have the Mitsubishi WL-82913 82" LCoS 1080P RPTV?

If so I have a few questions..

I bought a service manual on-line. It is 56 pages. I've seen others that are 67 pages. What is missing from my manual?

What input will accept 1080p? Is it only the 15 pin RGB, or will the DVI do it also?

I have a small convergence problem in the lower right side of the screen. Can it be adjusted?

Where is the best place to buy bulbs? With or without the housing?

Thanks for any info.

Pages

 

Connect With Techlore