Television and Home Theater

Hi Larry,

I changed the STK 392-570 ICs and then two 5A fuses on the G board. The tv is working fine. After repair I have observed that when I start the tv, picture is visible after ten blinks (front red LED) but the sound comes fraction of second before the picture. TV works fine. On your blinking diagnosis ten blinks means Q8014,8013 and R8051 and IC 8005. I feel sound output is a bit less as compared to was before repair i.e. I have to increase the volume level a bit, to get the same sound. (may be I am just having a false feeling).

Hi everyone,

I own a Mitsubishi WS-55313 that has recently shown symptoms similar to "Mitsubishi green flashing light" problems. I turn the TV on, the green LED stays lit for 3 seconds and then turns off.

The LED error code is 2-1 corresponding to X-Ray protect mode.

Group,

I have changed the lamp and the ballast in this set. The color wheel dos not look as if it is turning and the new lamp will not power on. The new ballast does have the 320 volts AC as it is suppose to have. The only thing I can figure out is that the connector from the ballast to the DMD board is not giving or the DMD board is not functioning.